That was fun
Worked on fixing an old fly rod that had a bad fracture. First I measured the damaged area and cut a fiberglass wand to length. This was followed by sanding it's diameter down to where it fit inside the rod. I glued the wand inside the rod with jb weld then covered the outside of the repair with more jb weld and wound a double layer of Dacron thread over the repair and into the jb weld before it set. Finally I added another layer of jb weld over the thread. Now to let it cure. I will find out tomorrow if it will hold up to casting. Now time for another cup of coffee and on to the next thing